Digital Input SW IN

Discussion and support for MoTeC's latest generation ECUs

Digital Input SW IN

Postby cotje on Fri Apr 16, 2021 5:43 am

Hi all, can someone explain how the Digital Input Sw In works? I noticed I can use a CAN signal from my ADL to trigger it. On my ADL2-channel I have a PDM-cycle-key programmed for ORB that has a cycled value of 0, 1 or 2.

The Dig Sw In is requiring the following fields that I programmed as follows
Source: 3 (ADL)
Channel: 2 (channel 2 is ORB value)
Lo level: 0
Hi level: 1

The problem is that whatever if use for Lo/Hi-level the Input is always showing status On

May someone can show me an example? TIA!
cotje
 
Posts: 58
Joined: Mon Oct 07, 2013 4:50 am

Re: Digital Input SW IN

Postby cotje on Fri Apr 16, 2021 6:28 am

Found it while I was posting the question. I had to use the multiplier in the SDL to get 1000/2000 values (mV) in the M800. I also had to change the polarity which resulted in a default=off switch state.
I can now trigger ORB map 1 or 2 from the Keypad>PDM>SDL>M800 :) Awesome technology !!
cotje
 
Posts: 58
Joined: Mon Oct 07, 2013 4:50 am


Return to M400, M600, M800 and M880 ECUs

Who is online

Users browsing this forum: No registered users and 5 guests