EJ207 Cam Position Sensors

Discussion and support for MoTeC's latest generation ECUs

EJ207 Cam Position Sensors

Postby Vlad on Thu Dec 31, 2020 2:55 pm

So, after reading again the M800 manual, i have a question about the EJ207 vr cam position sensor wiring to the DIG inputs. Since the DIG inputs have pullup resistors on them, i cannot just wire the vr sensors to them...is it possible to make a trick with +12V and pulldown resistor, similar like when wiring the 2wire abs sensors ? Or, i have no other way than going to hall sensors? Thanls
Vlad Pescaru
JPR Engineering, MoTeC Authorised Dealer
User avatar
Vlad
 
Posts: 105
Joined: Fri Oct 14, 2016 5:18 am
Location: Romania

Re: EJ207 Cam Position Sensors

Postby Vlad on Wed Jan 20, 2021 8:50 am

So? Anybody?
Vlad Pescaru
JPR Engineering, MoTeC Authorised Dealer
User avatar
Vlad
 
Posts: 105
Joined: Fri Oct 14, 2016 5:18 am
Location: Romania


Return to M400, M600, M800 and M880 ECUs

Who is online

Users browsing this forum: No registered users and 46 guests