Brake force display set up

Discussion and support for MoTeC Power Distribution Modules

Brake force display set up

Postby nybimmers1 on Sun Feb 21, 2021 2:40 pm

Hello folks ,

I am trying to set up a logic for brake force display on my track car .Basically when brake pressure goes over a certain brake pressure value to flash the brake lights but when below the specified ( brake pressure ) to just be constant on .
I have both brake light switch and brake pressure signals coming into the PDM over CAN . The brake lights are wired to only 1 output . Would it be possible to achieve such logic ? Basically when BLS condition is true lights stay constant on and when brake pressure signal becomes true turn/flash to off .I have attached my config file.

Much appreciated,

Adrian
Attachments
Brake_force_display.pdm
(112.06 KiB) Downloaded 200 times
nybimmers1
 
Posts: 2
Joined: Wed Feb 13, 2019 8:15 am

Re: Brake force display set up

Postby SDean on Mon Feb 22, 2021 8:36 am

Hi,

Give this a try.
Attachments
Brake_force_display_mod.pdm
(120.88 KiB) Downloaded 217 times
Stephen Dean
MoTeC Research Centre Melbourne, Australia
User avatar
SDean
Site Admin
 
Posts: 1003
Joined: Tue Dec 02, 2014 9:29 am
Location: Melbourne

Re: Brake force display set up

Postby nybimmers1 on Thu Feb 25, 2021 7:13 am

Thank you Stephen ! Worked fine .
nybimmers1
 
Posts: 2
Joined: Wed Feb 13, 2019 8:15 am

Re: Brake force display set up

Postby SDean on Thu Feb 25, 2021 7:46 am

Glad to hear. :D
Stephen Dean
MoTeC Research Centre Melbourne, Australia
User avatar
SDean
Site Admin
 
Posts: 1003
Joined: Tue Dec 02, 2014 9:29 am
Location: Melbourne


Return to PDM15 PDM16 PDM30 and PDM32

Who is online

Users browsing this forum: No registered users and 2 guests

cron