Is MDC CAN terminated in the box?

Discussion and support for MoTeC's Mitsubishi and Subaru Diff Controllers

Is MDC CAN terminated in the box?

Postby Mazi on Fri Apr 15, 2011 5:49 am

Cars are not at home so I can't find out...
User avatar
Posts: 145
Joined: Thu Jul 24, 2008 7:45 pm

Re: Is MDC CAN terminated in the box?

Postby OmarK on Thu May 03, 2012 4:48 pm


By default from factory there is no CAN termination resistor active in the MDC. But if you look at the MDC user manual you will see that a link can be soldered inside the MDC but this is not recommended as it cannot be obvious to others if the resistor is connected. So we would recommend putting a resistor on the CAN bus wires externally of the box if the MDC is one end of your CAN bus main trunk.
Posts: 214
Joined: Mon Nov 10, 2008 3:39 pm

Return to MDC and SDC

Who is online

Users browsing this forum: No registered users and 1 guest