Page 1 of 1

Fail to connect to ECU

PostPosted: Thu Oct 21, 2021 5:28 pm
by NUS-FSAE_Nigel
Hi, I have been using my M150 ECU for about 2 years now.

I have recently run into a problem whereby I am unable to connect to my ECU using the ethernet port.
On startup, I am able to detect the ECU through M1 tune however, once I try to retrieve the package from it, the error message given is "Failed to retrieve Tuning Data". A screenshot of the problem is attached in the post below.

I have tried force sending a new package to the ECU by pressing Ctrl + Alt and clicking on send but the problem persists.

Any assistance would be very much appreciated. Thank you!