V2 Configuration on Additional Micro SD cards used..?

Forum for discussions on the MoTeC V2 Camera system

V2 Configuration on Additional Micro SD cards used..?

Postby proformance on Thu May 31, 2018 3:15 pm

Is it necessary to have the V2 configuration on each 32GB Micro SD card inserted into the V2 Camera.?

(Or, in other words.)

If once the V2 Camera is configured via a micro SD card, may a blank 32GB Micro SD card be inserted and have the V2 Camera operate and record properly.....? Post being powered "OFF" for several weeks.?

Also, I have had no success with the V2 recording in US values (IE: MPG and PSI.) I have these channels default to MPH and PSI in the Dash config, but I can only get KPH and KPA to record. Are there recommendation on how to remedy this?

Thanks
Gary
proformance
 
Posts: 12
Joined: Sat May 15, 2010 2:38 pm

Re: V2 Configuration on Additional Micro SD cards used..?

Postby adrian on Thu May 31, 2018 4:44 pm

The configuration only needs to be on the SD card for one power up. After that it is saved permanently to the device. You can use a blank SD card from then on, you only need the configuration files again if you want to change some settings.

Below is a CAN template that will transmit the channels to the v2 in Imperial units.
Attachments
v2_Transmit_Imperial_0x01F_Version 1.CC7
(8.12 KiB) Downloaded 565 times
adrian
MoTeC
 
Posts: 683
Joined: Mon Apr 13, 2015 4:16 pm


Return to V2

Who is online

Users browsing this forum: No registered users and 1 guest